Toggle Control Plate

Want a toggle instead of a blade switch? Here you go. CRS chrome or nickel plated.

Be the first to review this product

Control Plate Option *

$0.00

Qty:

Customers who bought this item also bought

Traditional Switch Tip (Black Nickel Plate)

Traditional switch tip. Machined brass black nickel plate. Set screw holds it on for some abuse. Fits typical 3 or 5 way blade switch.

$25.00

Rutters 1953 T Knobs

I have had quite a few requests for this knob - seems some like the bullet/dome top look. The knurl was all over the place in "53," so I picked the one I liked. The knurl is a bit sharp so a one finger spin is easy. Hand machined the old way, by me. 1/4'' solid shaft.

*Note* One order is for two (2) knobs.

$0.00

3/8" Over Control Plate

3/8'' over Control Plate, 16 guage (0.06") cold-rolled steel, and chrome plated. Volume knob position is an additional 3/8" from the selector switch.

$0.00

Rutters Vintage Stamped Bridge, Nickel Plate

Cold roll steel 16 gauge (0.58"); just a bit thicker for added strength. The original was 18 gauge (0.048"). Between the added thickness and my bending method, this one is stiff and extremely flat, solving that "squealing" issue. The added thickness does not take away any "Twang". Use the Broadcaster saddles for that woody throaty tone, or the brass saddles for a thicker warmer tone.

$0.00