Rutters 1953 T Knobs

I have had quite a few requests for this knob - seems some like the bullet/dome top look. The knurl was all over the place in "53," so I picked the one I liked. The knurl is a bit sharp so a one finger spin is easy. Hand machined the old way, by me. 1/4'' solid shaft.
*
$0.00
Customers who bought this item also bought

Rutters Vintage Stamped Bridge, Nickel Plate

Cold roll steel 16 gauge (0.58"); just a bit thicker for added strength. The original was 18 gauge (0.048"). Between the added thickness and my bending method, this one is stiff and extremely flat, solving that "squealing" issue. The added thickness does not take away any "Twang". Use the Broadcaster saddles for that woody throaty tone, or the brass saddles for a thicker warmer tone.
$0.00

Rutters Nocaster Knob

Hand machined brass with a soft round head; slightly smaller than the “Broadcaster” and now with your choice of chrome or nickel plating. 8-32 slotted steel nickel plated set ,screw included. 1/4'' solid shaft.
$0.00

50's Control Plate

18 gauge cold roll steel and chrome plated.
$0.00

Rutters Cup

Finally a machined jack cup that stays put and which can be easily removed if needed; and most importantly, it looks correct. Machined from billet aluminum; your choice of chrome or nickel plating, supplied with polished stainless mounting screws and threaded to fit the “switchcraft” input jack.
$0.00